Retarding thinner DILUENTE GRIP
A retarding thinner that improves the penetration and adhesion of water-based finishes and primers on difficult supports…
Coats recommended
Profits
- Improves penetration and bonds of water-based sealers and finishes
- Compatible with all Carver water-based sealers and finishes
Product informations
A retarding thinner that improves the penetration and adhesion of water-based finishes and primers on difficult supports.
This product is compatible with all Carver water-based finishes and primers.
Packaging: 1L
| Destination | Intérieur-6vs5f5jzlyd3 |
|---|
Documents
Preparation
DIRECTIONS
Pour DILUENTE GRIP into the primer/finish and mix thoroughly until fully dissolved. Wait 10 - 15 minutes, then apply.
NOTICE
- This product is not compatible with solvent-based systems.
- Too much DILUENTE GRIP greatly reduces the viscosity of the product and greatly increases its drying times
Protect from freezing!
Dispose of excess product and empty containers properly.
If the original unopened container is stored in a cool and dry place, the product will keep for at least 12 months.
