Water-based acrylic impregnation WPC AQUAPRO
Water-based acrylic stain for staining and protecting WPC for both indoor and outdoor use…
- High UV and damp protection
- Ready to use
Product informations
Water-based acrylic stain for staining and protecting WPC for both indoor and outdoor use.
Protects the treated object against water and UV radiation. It can be used both for treatment of new WPC as well as restoration of tarnished WPC.
WPC AQUAPRO is available in various colours. All colours can be mixed together.
Packaging: 5L
| Destination | Extérieur-jfc5f5jzo74l |
|---|
Documents
Preparation
PREPARATION OF THE SUPPORTE
New WPC: wash with a solution of water and OUTDOOR DETER PRO, rinse thoroughly and allow to dry.
Tarnished WPC: apply our PULIDECK detergent with a brush and wait for at least 15-20 minutes. Remove the surface film with a semi-rigid brush or red Scotch Brite. Rinse with water and leave to dry (the film can also be removed with a pressure hose).
APPLICATION
When the support is dry, apply one or two coats of WPC AQUAPRO by brush, dabber or spray.
MAINTENANCE
For cleaning only, wash the WPC floor with a solution of water and OUTDOOR DETER PRO.
To restore a tarnished floor, treat it with PULIDECK as described above and proceed with a new treatment.
NOTICE
- In case of use in open sites, it is recommended not to apply the product in environments directly exposed to the sun and, in any case, to climatic conditions such as rain, snow or ice.
- Apply at a temperature between +15°C and +35°C with a relative humidity rate between 35% and 80%. Allow product to acclimatize before application.
- The colour tone can vary significantly depending on the type of WPC, its preparation, the method of application and the quantity of product applied. It is therefore recommended to perform a test before proceeding with the entire job.
Protect from freezing! Dispose of excess product in authorized dumps! If the original unopened container is stored in a cool and dry place, the product will keep for at least 12 months.
